How to install ceramics on the floor

Find the center point of the floor area. The center point can be determined by measuring the crossing of one corner of the room to the other. Then mark the measured mid-line. Finding the center point is a top priority, as this will determine where to install the first and the next ceramics. In the meantime, you might also need to see the florida handyman license service, if you want to become a trusted handyman.

Begin the first tile installation from the center point to one wall.

Apply ceramic adhesive mortar with a spark (better serrated) evenly on the floor. The range of adhesive applications should not be too broad enough for 3-4 ceramic tiles. It is feared that the adhesive will dry out quickly, so the bond on the ceramic is not good.

Place the ceramic on top, and press down slowly, and tap with a rubber hammer until the tile position is stable. When tapping the ceramic, make sure you check the sound that arises. If the buzzing sound means there is an adhesive that does not glue on the ceramic. Immediately lift the ceramic and repair the adhesive stirring evenly and paste it in its original position.

Use a tile spacer and continue installing the next tile.

Use an aluminum water pass to release the ceramic height evenly. If you see an uneven surface, you can add or reduce ceramic adhesive mortar until it is even.

When installing at the end of the line, measure the ceramic to be cut by placing it on top of the last ceramic tile, and by making room for grout. Mark with markers on the ceramic to be cut.

Repeat steps 2 to 7 for the next ceramic row.

Leave it for one and a half days so the ceramic adhesive mortar dries.

Fill the grout with grout. Grout is a mortar (cement) that is used to fill the void or ceramic slit.

Clean the excess grout using a wet sponge.

Leave a Reply

Your email address will not be published. Required fields are marked *